Skip to main content

Star Delta Starter with Arduino Nano

This project about star delta connection for a three phase motor. I did'n have three phase induction motor so I used three signal lamp instead. In star delta connection first, star connection actives and then after a while delta connection will active. The time between star and delta connection depends on how powerful your motor is. In this project it is possible to change the time from 0 second to 100 seconds by potentiometer connected to A0. I used Arduino Nano instead of any industrial PLC. The outputs of the Arduino is connected to the relay board and then it is connected to contactors. Contactor is a devise that can connect three phase voltage to an induction motor. There is a video of how this circuit works.

Download link:
Labels:

Comments

  1. UnknownDecember 7, 2019 at 8:47 AM

    Good idea. I like

    ReplyDelete
    Replies
    1. Saman ShahsiahDecember 29, 2019 at 3:33 AM

      Thank you

      Delete
    2. UnknownAugust 11, 2020 at 7:43 PM

      I want to make this project for my college

      I am ready to pay service charge .
      Please reply fast.

      Delete
  2. krisnaJanuary 14, 2020 at 7:48 PM

    hello sir!! can you take me for this Circuit ?? what is used to make this?

    ReplyDelete
  3. Kifayatullah KalwarApril 27, 2020 at 10:03 AM

    Downloading link is not working?

    ReplyDelete
  4. AhmedJuly 18, 2020 at 12:25 PM

    Downloading link is not working?

    ReplyDelete
    Replies
    1. jayantha sarangaAugust 10, 2020 at 12:31 AM

      downloading is not working,please send the detail to my email
      jayanthasaranga@gmail.com

      Delete
  5. UnknownSeptember 14, 2020 at 4:23 AM

    dear need for my project i will be very thanks full to you if you send me circuit and code
    engr.asad1987@gmail.com

    ReplyDelete

Post a Comment

Popular posts from this blog

Single phase half-wave diode rectifiers

Half-wave rectifier with resistive load: Half-wave rectifier with R-L load: Half-wave rectifier with freewheeling diode: Half-wave rectifier with capacitor filter: Download link: https://drive.google.com/open?id=1609_GDuzLA2BWE0a7nPnaERC9rhMrg8N                          
Post a Comment
Read more

I2C LCD with Arduino Nano

This project is about connecting 16*2 LCD thorough I2C protocol with Arduino Nano. The advantage of using I2C protocol for connecting LCD is that it uses only 2 ports of your Arduino while if you want to connect LCD directly to the arduino  it uses at least 6 ports. There is a shield of course to translate I2C commands for LCD and first you need to get I2C library for arduino and install it on your IDE. Download link: https://drive.google.com/open?id=1iuaCFyH-HoGGssdio45KEtStTvtxIGD2
Post a Comment
Read more