Skip to main content

Star Delta Starter with Arduino Nano

This project about star delta connection for a three phase motor. I did'n have three phase induction motor so I used three signal lamp instead. In star delta connection first, star connection actives and then after a while delta connection will active. The time between star and delta connection depends on how powerful your motor is. In this project it is possible to change the time from 0 second to 100 seconds by potentiometer connected to A0. I used Arduino Nano instead of any industrial PLC. The outputs of the Arduino is connected to the relay board and then it is connected to contactors. Contactor is a devise that can connect three phase voltage to an induction motor. There is a video of how this circuit works.

Download link:
Labels:

Comments

  1. UnknownDecember 7, 2019 at 8:47 AM

    Good idea. I like

    ReplyDelete
    Replies
    1. Saman ShahsiahDecember 29, 2019 at 3:33 AM

      Thank you

      Delete
    2. UnknownAugust 11, 2020 at 7:43 PM

      I want to make this project for my college

      I am ready to pay service charge .
      Please reply fast.

      Delete
  2. krisnaJanuary 14, 2020 at 7:48 PM

    hello sir!! can you take me for this Circuit ?? what is used to make this?

    ReplyDelete
  3. Kifayatullah KalwarApril 27, 2020 at 10:03 AM

    Downloading link is not working?

    ReplyDelete
  4. AhmedJuly 18, 2020 at 12:25 PM

    Downloading link is not working?

    ReplyDelete
    Replies
    1. jayantha sarangaAugust 10, 2020 at 12:31 AM

      downloading is not working,please send the detail to my email
      jayanthasaranga@gmail.com

      Delete
  5. UnknownSeptember 14, 2020 at 4:23 AM

    dear need for my project i will be very thanks full to you if you send me circuit and code
    engr.asad1987@gmail.com

    ReplyDelete

Post a Comment

Popular posts from this blog

Blinking LED by STM32F103C8T6

This post is about running a blinking LED with STM32F103C8T6. This code was written in MDK Version 5 - Keil. I used a transistor as a driver to prevent MCU from over current cause ARM CPUs work with 3.3v and can not provide high current output. I uploaded program with ST-LINK programmer. Delay is 500 ms and you can change it in the program. There is a simulation in Proteus. Download link: https://drive.google.com/open?id=1b5yuQiFmAGQk1EN5_WoC0AhpC-9L2_Co
Post a Comment
Read more

Write on 4-digit 7-segment with keypad by Arduino Nano

This post is about how to use a keypad for writing on 4-digit 7-segment. The program can be used when you want to add number to your program. I keep the number into a variable and also it can be seen on your 7-segment at the same time. I did not use any special 7-segment IC driver and it is running just by refreshing all the time. You can also clear the number and add it again. Download link: https://drive.google.com/open?id=1e29RDuZhZqAuWE6OfeeHcSGl3NJpqpSV
Post a Comment
Read more