Skip to main content

Up and down blinking LED's with push button control

In this post I shared a project which is about 6 LED's that will blinking one after the other and there is a push button to control in which direction they should be blinking. You can change both the direction of blinking and the speed of it.



here is the link for program in Arduino:
here is the link for schematic in Proteus:

Labels:

Comments

Post a Comment

Popular posts from this blog

Star Delta Starter with Arduino Nano

This project about star delta connection for a three phase motor. I did'n have three phase induction motor so I used three signal lamp instead. In star delta connection first, star connection actives and then after a while delta connection will active. The time between star and delta connection depends on how powerful your motor is. In this project it is possible to change the time from 0 second to 100 seconds by potentiometer connected to A0. I used Arduino Nano instead of any industrial PLC. The outputs of the Arduino is connected to the relay board and then it is connected to contactors. Contactor is a devise that can connect three phase voltage to an induction motor. There is a video of how this circuit works. Download link: https://drive.google.com/open?id=1rkaE7WTPg93gEQ8l0ehYUHintUx-WcQG
8 comments
Read more

Single phase half-wave diode rectifiers

Half-wave rectifier with resistive load: Half-wave rectifier with R-L load: Half-wave rectifier with freewheeling diode: Half-wave rectifier with capacitor filter: Download link: https://drive.google.com/open?id=1609_GDuzLA2BWE0a7nPnaERC9rhMrg8N                          
Post a Comment
Read more

I2C LCD with Arduino Nano

This project is about connecting 16*2 LCD thorough I2C protocol with Arduino Nano. The advantage of using I2C protocol for connecting LCD is that it uses only 2 ports of your Arduino while if you want to connect LCD directly to the arduino  it uses at least 6 ports. There is a shield of course to translate I2C commands for LCD and first you need to get I2C library for arduino and install it on your IDE. Download link: https://drive.google.com/open?id=1iuaCFyH-HoGGssdio45KEtStTvtxIGD2
Post a Comment
Read more