Skip to main content

How to read keypad using LCD

This post is about showing how you can read a keypad and see what you just typed on it. I used a keypad as an input device and used one LCD that shows us what we just typed. We don't want to do any mathematics operation with keypad. All we want is just showing what we are typing.


Comments

Popular posts from this blog

Star Delta Starter with Arduino Nano

This project about star delta connection for a three phase motor. I did'n have three phase induction motor so I used three signal lamp instead. In star delta connection first, star connection actives and then after a while delta connection will active. The time between star and delta connection depends on how powerful your motor is. In this project it is possible to change the time from 0 second to 100 seconds by potentiometer connected to A0. I used Arduino Nano instead of any industrial PLC. The outputs of the Arduino is connected to the relay board and then it is connected to contactors. Contactor is a devise that can connect three phase voltage to an induction motor. There is a video of how this circuit works. Download link: https://drive.google.com/open?id=1rkaE7WTPg93gEQ8l0ehYUHintUx-WcQG

Single phase half-wave diode rectifiers

Half-wave rectifier with resistive load: Half-wave rectifier with R-L load: Half-wave rectifier with freewheeling diode: Half-wave rectifier with capacitor filter: Download link: https://drive.google.com/open?id=1609_GDuzLA2BWE0a7nPnaERC9rhMrg8N                          

Traffic light by STM32F103C8T6

This project is about simulating a traffic light. There is a 1-digit common anode 7-segment which shows how long each signal is on. I connected three 220v signal lamp as its lights by a relay board which its relays work at 5v. Output voltage of stm32f103c8t6 is 3.3v so I used three transistors as switches to convert 3v output to 5v that is needed for relay board. Download link: https://drive.google.com/open?id=1UVHMYvGlCxITk0jRz3Y8TPV_h8HHZmJN